Ricoh FT5233 Service Manual page 185

SERVICE PROGRAM MODE
NOTE: 1. An SP mode number will blink in the copy counter. The Copy
Counter will stop blinking and stay on when the Enter key is
pressed.
2. When the SP mode number is blinking, it can be changed by
pressing the Clear/Stop key and entering a new number. The
SP mode number can also be changed by using the Zoom
keys ("+" & "–").
3. If the Enter key is pressed with an invalid SP mode number,
the Max indicator will blink and the Copy Counter number will
change to "0". In this case, Enter a valid SP mode number and
press the Enter.
6. To leave the SP mode, press the Clear Modes key.
Access Procedure 2: Main switch and number keys
Accessible SP mode numbers:
All SP mode numbers except SP99 (memory all clear).
1. Turn the main switch off.
2. While pressing both 1 and 3 on the operation panel number keys, turn on
the main switch.
NOTE: Release the number keys after confirming that the Call Service
indicator and the Copy Counter number "0" are blinking.
3. Enter the desired SP mode number using the number keys and press the
Enter key.
NOTE: 1. An SP mode number will blink in the Copy Counter. The Copy
Counter will stop blinking and stay on when the Enter key is
pressed.
2. When the SP mode number is blinking, it can be changed by
pressing the Clear/Stop key and entering the new number. The
SP mode number can also be changed by using the zoom
keys ("+" & "–").
3. If the Enter key is pressed with an invalid SP mode number,
the Max indicator will blink and the Copy Counter number will
change to "0". Enter a valid SP mode number and press the
Enter key.
4. To leave the SP mode, turn off the main switch.
4-8
12 February 1992