Ricoh FT5233 Service Manual page 309

12 February 1992
[H]
[D]
[F]
5. Unhook the lift spring [A] from the duplex lift lever [B] and the cam clutch
[C].
6. Remove 3 clamps [D] with a pair of pliers.
7. Disconnect CN602, and CN603 [E] from the duplex control board.
8. Disconnect the sensor connector [F] from the jogger home position
sensor.
9. Disconnect the connectors [G, H] from the duplex turn gate solenoid and
from the duplex entrance sensor.
10. Remove the duplex unit [I] (4 screws) from the tray.
NOTE: Hold both sides of the duplex unit frame when lifting the duplex
unit out of the tray.
[I]
[G]
5-79
DUPLEX
[C]
[A]
[B]
[E]
[D]