Ricoh FT5233 Service Manual page 333

12 February 1992
[B]
4. Remove the small lens cover [A] (2 screws).
5. Mark the original position of the lens assembly on the lens bracket.
6. Loosen the 2 screws, shift the lens assembly [B] according to the
following rule, and tighten the screws.
If the image is shifted to the rear: shift the lens assembly to the front.
If the image is shifted to the front: shift the lens assembly to the rear.
7. Place the exposure glass and turn on the main switch.
8. Make a copy and check the results of the adjustment.
9. If the adjustment is still not correct shift the lens position again.
CAUTION: Be sure that the main switch is off when adjusting.
10. Reassemble the copier.
COPY QUALITY ADJUSTMENT
5-103
[A]