Ricoh FT5233 Service Manual page 310

DUPLEX
[I]
[H]
[J]
-Installation-
1. When placing the duplex unit back into the tray, hold up the bottom plate
[A] so that the flipmylar brackets [B] fit under it as shown.
2. Hook the lift spring [C] to the cam clutch [D] and the duplex lift lever [E] as
shown.
NOTE: When installing the duplex unit, make sure of the following:
a) The positioning pin [F] fits through hole [G] in the side plate.
b) The positioning rib [H] fits through the cutout [I] in the side
plate.
c) The sensor harness [J] is not caught under the unit frame.
[C]
[G]
5-80
12 February 1992
[D]
[E]
[B]
[A]
[G]
[F]