COPIER INSTALLATION
[A]
[C]
6. Remove the 2 corners [A] of the left bottom cover [B] as shown with the
cutting pliers.
7. Install the sorter adapter [C] (4 screws) on the paper exit section of the
copier.
•
NOTE:
The front upper right part of the sorter adapter bracket [D]
should be placed in-between the copier front side plate and
the upper exit cover.
•
The top and the bottom screw holes of the rear bracket
should be used for securing the sorter adapter.
8. Swing out the dc power supply board assembly [E] (1 screw).
9. Install the gear assembly [F] (3 screws) on the copier rear side plate as
shown.
NOTE: The positioning hole of the gear assembly bracket [G] should fit
over the positioning stud of the copier drive gear. Also, the
positioning pin of the gear assembly [H] should be placed in the
positioning hole of the sorter adapter bracket.
10. Reinstall the dc power supply board.
[D]
[B]
3-28
12 February 1992
[H]
[F]
[E]
[G]