Registration Clutch Replacement - Ricoh FT5233 Service Manual

12 February 1992
5.5

REGISTRATION CLUTCH REPLACEMENT

[A]
1. Turn off the main switch and unplug the power cord.
2. Remove the rear cover.
3. Take the high voltage cables off the hooks on the exhaust blower housing.
4. Remove the exhaust blower assembly [A] (2 screws and 1 connector).
5. Remove the exhaust blower bracket [B] (1 spring [C] and 1 screw).
6. Remove the stopper bracket [D] (1 screw).
7. Remove the registration clutch [E] (1 E-ring, 1 connector, 1 wire saddle).
NOTE: When reinstalling the clutch, make sure that the clutch stopper
pin [F] engages with the groove of the stopper bracket.
[E]
[F]
[D]
[B]
5-43
PAPER FEED
[C]