Ricoh FT5233 Service Manual page 828

12 February 1992
[B]
[A]
9. Pass the harnesses [A] through the access hole and connect the sorter
stapler with the copier. Make sure that the stud on the front connecting
bracket [B] is positioned in the sorter stapler positioning hole.
NOTE: Be careful not to damage the harnesses when connecting the
sorter stapler with the copier.
10. Secure the protective earth wire [C] under the power cord terminal (1
grounding screw with toothed washer), and couple the 3 connectors as
follows:
Sorter Stapler Connector
2p (Fiber Optic Cable)
NOTE: Run the fiber optics cable [D] as shown and set it in the wire
saddles [E].
2p (Red)
4p (White)
27
INSTALLATION PROCEDURE
[D]
Copier Connector
2p (Red)
4p (White)
CN703 on the interface
PCB
[C]
[E]