Central Office Calls, Placing - NEC Electra Elite IPK II System User Manual

Electra Elite IPK II
Description
The system provides flexibility in the way each extension user can place outgoing trunk calls. This lets
you customize the call placing options to meet site requirements and each individual's needs. A user
can do one of the following to place a call:
Press a Line Key

Press a Trunk Group Key

Press a Trunk Group Routing (dial 9) Key

Dial a code for a specific trunk (

Dial a code for a Trunk Group (704 + group number)

Dial a code for Trunk Group Routing or ARS (9)

Dial an Alternate Trunk Route Access Code (which you must define)

Press or Use a Speed Dial bin

There are 200 available trunks.
Trunk Port Disable
The system provides a service code (default: 645) which can be used by an extension user to block a
trunk for outgoing calls. The user which busied out the trunk still has access to it. All other users are
blocked from seizing it to place an outgoing call. The trunk, however, can still be answered by any user
programmed with trunk access.
Sidetone Volume Setup
Allows the system programming for the multiline terminal side tone volume. There are two levels, based
on whether the connected trunk is a digital trunk or analog trunk.
Conditions
If the trunk name seize display is enabled in programming, the Call Timer starts

automatically after the user places a trunk call. Disabling the trunk name seize display also
disables the Call Timer.
The system can automatically select the correct type of line to use based on the number

dialed and the time.

Central Office Calls, Placing

Central Office Calls, Placing
9 + the trunk number)
#
Document Revision 4C
2 - 195