NEC Electra Elite IPK II System User Manual page 433

Electra Elite IPK II
The Gateway power supply and cables should be installed away from high power/high RF

noise devices such as computers, fans, fluorescent ballast, or power supplies.
Good wiring practices are required. Do not run wires across devices such as fluorescent

lights, computers, or air conditioners to avoid introducing noise in the modems.
The distance between the PBX/KTS and the Gateway unit must not exceed 500 feet.

When 5-, 6-, or 7-digit station numbers are used, this feature is not available.

Default Setting
None
System Availability
Terminals
DTU/DTP/DTR Multiline Terminals

DTP-32DE-1 for home environment

Required Component(s)
Components include the following:
Electra Elite IPK II KTS with one ESI port for each Branch port and IP Adapter

Gateway unit

Branch unit and/or IP Adapters with total ports not exceeding the number of ports

supported by the Gateway unit
Power Cord

RS-530 cable

2 RJ-21 50-pin cables to connect Gateway to DTS and Branch to punch block – connectors

required include a female connector to attach to D
the KTS.
Punch blocks that can cross-connect the D

telephones to the branch locations.
Installation hardware for Gateway and Branch units

System Administrator's Guide

Quick Installation Guide

term
D IP Gateway System
term
IP, and a male connector to attach to
term
IP Gateway to the KTS and D
Document Revision 4C
term
2 - 409