NEC Electra Elite IPK II System User Manual page 510

Document Revision 4C
Related Features
Handsfree and Monitor
Microphone Cutoff
Programming

11-11-15 Service Code Setup (for Setup/Entry Operation) – Enable Handsfree Incoming Intercom
Calls
If required, change the service code used for setting an extension to voice announce for
incoming ICM calls (default: 721).

11-11-16 Service Code Setup (for Setup/Entry Operation) – Force Ringing of Incoming Intercom
Calls
If required, change the service code used for setting an extension to forced ringing for incoming
ICM calls (default: 723).

11-12-06 Service Code Setup (for Service Access) – Switching of Voice Call and Signal Call
If required, change the service code used for toggling an outgoing ICM call between a voice call
and signal call (default: 712).

15-02-16 Multiline Telephone Basic Data Setup – Handsfree Operation
Enable (1)/Disable (0) an extension user ability to use the speakerphone on outside calls. Users
can hear the conversation, but cannot respond handsfree.

20-02-12 System Options for Multiline Telephones – Forced Intercom Ring (ICM Call Type)
Enable (1)/Disable (0) Forced Intercom Ringing. If disabled, Intercom calls voice-announce.

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.

20-08-10 Class of Service Options (Outgoing Call Service) – Signal/Voice Call
Enable (1)/Disable (0) an extension user ability to toggle between Handsfree Answerback and
Forced Intercom Ringing for outgoing Intercom calls (dial 1 or Service Code 712).

20-09-05 Class of Service Options (Incoming Call Service) – Signal/Voice Call
Enable (1)/Disable (0) an extension user ability to set Handsfree Answerback (Service Code
721) and Forced Intercom Ringing (Service Code 723) for incoming Intercom calls.
2 - 486 Handsfree Answerback/Forced Intercom Ringing
Electra Elite IPK II