NEC Electra Elite IPK II System User Manual page 199

Electra Elite IPK II

14-02-16 Analog Trunk Data Setup – Caller ID Type
Select the type of Caller ID signal from an analog trunk – FSK (0) or DTMF (1). By default, this
option is set to 0.
Trunks: 1~200

15-02-08 Multiline Telephone Basic Data Setup – Automatic Handsfree
Set whether pressing a key accesses a One-Touch Key (1) or preselects the key (0).

15-02-40 Multiline Telephone Basic Data Setup – Additional Dial for Caller ID Call Return (Version
1600 and 2100 or higher required)
Up to eight digits (0, 1~9, #,

15-03-09 Single Line Telephone Basic Data Setup – Caller ID Function – For External Module
Enable (1)/Disable (0) the Caller ID FSK signal for an external Caller ID module or a 3rd party
vendor telephone with Caller ID display. If voice mail is used, this setting must be disabled or the
system integration codes for disconnect are incorrect. For Caller ID Sender Queuing, set this
option to 1.

15-03-10 Single Line Telephone Basic Data Setup – Caller ID Name
Determine whether or not an single line telephone extension user telephone should display the
Caller ID name (0 = Disable, 1 = Enable).

15-03-11 Single Line Telephone Basic Data Setup – Caller ID Type
Select the type of Caller ID signal sent from an SLT extension port – FSK (0) or DTMF (1). By
default, this option is set to 0.

15-07-01 Programmable Function Keys
Assign an Outgoing Call Without Caller ID (ISDN) function key (63) or a Caller ID Log History
key (08) if needed.

20-02-08 System Options for Multiline Telephones – LCD Display Holding Time
Determine the time a user display shows Caller ID for a second incoming call (0~64800
seconds).

20-06-01 Class of Service for Extensions
Assign Class of Service (1~15) to extensions.

20-08-15 Class of Service Options (Outgoing Call Service) – Block Outgoing Caller ID
Allow (1)/Prevent (0) a user Class of Service from automatically blocking outgoing Caller ID
information when a call is placed. If block is enabled, the system automatically inserts the Caller
ID block code
PRG 14-02-10 to be enabled). If block is disabled, the system outdials the call just as it was
dialed by the user.

20-09-02 Class of Service Options (Incoming Call Service) – Caller ID Display
Enable (1)/Disable (0)) the extension ability to display incoming Caller ID name/number
information.
This is disabled at default.

Caller ID
 ) (default not assigned).
67 (defined in Program 14-01-21) before the user dialed digits (this requires

Document Revision 4C
2 - 175