Document Revision 4C
VoIP ToS Setup
The Elite IPK II supports Quality of Service Marking for the Type of Service and DiffServe on the
following VoIP Applications: (MG16 and CCISoIP packages)
84-10-01
ToS Setup – ToS Mode
Define the logic used for marking the ToS Field.
(default: 0)
84-10-02
ToS Setup – Priority, IP Precedence
Define the IP Precedence data bit.
(default: 0)
Typically, only one of bits 3 ~ 6 are set to 1 and the other three bits are set to 0. For example, to maximize
route reliability, set PRG 84-10-05 to 1, and leave PRG 84-10-03, PRG 84-10-04 and PRG 84-10-06 at 0.
84-10-03
ToS Setup – Low Delay
1 = Optimize for low delay routing.
(default: 0)
84-10-04
ToS Setup – Wideband (Throughout)
1 = Optimize for high bandwidth routing.
(default: 0)
84-10-05
ToS Setup – High Reliability
1 = Optimize for reliability routing.
(default: 0)
84-10-06
ToS Setup – Low Cost
1 = Optimize for low cost routing
(default: 0)
84-10-07
ToS Setup – Priority (D.S.C.P. - Differential Services Code Point)
Define the Diffserve – decimal value (valid values 0~63)
(default: 0)
Firmware Download Setup
Use this data program to configure the required settings for Center Download file server access.
84-07-01
Firmware Download Setting – Server Mode
Select the mode type.
0 = TFTP, 1 = FTP
(default: 0)
84-07-02
Firmware Download Setting – File Server IP Address
Set the IP Address for the file server.
(default: 0.0.0.0)
2 - 546
Electra Elite IPK II
IP Station (MEGACO) – MG 16