NEC Electra Elite IPK II System User Manual page 671

Electra Elite IPK II
SMDR Dialed Digits for either ISDN – BRI or PRI

35-02-15 SMDR Output Options – CLI/DID Number Switching
Determine if the CLI/DID Number should be displayed.
0 = Caller ID Number (Default)
1 = DID Calling Number
2 = Caller ID Name

35-02-16 SMDR Output Options – Trunk Name or Received Dialed Number
Determine how the SMDR should print incoming calls on ANI/DNIS or DID trunks. If set to (1),
ANI/DNIS trunks can print DNIS digits, if set to (0) trunk names are printed instead.
For additional SMDR Services refer to

General ISDN Programs

14-01-13 Basic Trunk Data Setup – Trunk-to-Trunk Transfer
For each trunk that is able to participate in a tandem call, enter 1. To disable a trunk from
Tandem Trunking, enter 0 (default setting: 1). Required for 2 B-Channel transfer.

15-02-29 Multiline Telephone Basic Data Setup – PB Back Tone Level
Adjust the PB Back Tone level when calling an ISDN line. [Entries: 1~-63 (-15.5 to +15.5 db in
0.5 dB steps), default: 32].

15-07-01 Programmable Function Keys
Assign a function key for Caller ID Block for ISDN (63) if required.

20-06-01 Class of Service for Extensions
Assign a Class of Service to extensions.

20-09-02 Class of Service Options (Incoming Call Service) – Caller ID Display
Enable (1)/Disable (0) the extension ability to display incoming Caller ID name/number
information.

20-09-03 Class of Service Options (Incoming Call Service) – Sub Address Identification
Define whether an extension displays the Caller Sub-Address, 0 = Deny, 1 = Allow.

20-11-11 Class of Service Options (Hold/Transfer Service) – Auto On-Hook Transfer
Enable (1)/Disable (0) an extension user ability to transfer when the user hangs up.

20-11-14 Class of Service Options (Hold/Transfer Service) – Trunk-to-Trunk Transfer Restriction
Allow (0)/Deny (1) Trunk-to-Trunk Transfer (default: 1). Required for 2 B-Channel transfer.

20-11-21 Class of Service Options (Hold/Transfer Service) – Restriction for Tandem Trunking on
Hang Up
Allow (0) an extension user to set up a tandem call automatically when they hang up.
ISDN Compatibility
Station Message Detail Recording on page
Document Revision 4C
2-913.
2 - 647