NEC Electra Elite IPK II System User Manual page 396

Document Revision 4C

15-02-38 Multiline Telephone Basic Data Setup – Voice Mail Message Wait Lamp Cycle (Version
1600 or higher required)
1 = Cycle 1
2 = Cycle 2 (default)
3 = Cycle 3
4 = Cycle 4
5 = Cycle 5
6 = Cycle 6
7 = Cycle 7

20-13-49 Class of Service Options (Supplementary Service) – BLF Indication on CO Incoming State
(Version 1600 or higher required)
Turn Off (0) or On (1) the BLF Indication when a Ring Group call rings a station. This
assignment does not apply to single line telephones.

20-15-01
through
20-15-11 Ring Cycle Setup
Define the ringing cycles for each ring tone, when Synchronous Ringing is disabled.

22-03-01 Trunk Ring Tone Range
Set the ring tone range (1~9) for each trunk.

80-01-01 Service Tone Setup – Repeat Count
Customize the system basic tones and system service tones. You must reset the system for the
changes to take affect.

80-01-02 Service Tone Setup – Basic Tone Number
The following features require that the system tones listed below be changed to match the table.
After changing these settings the KSU must be reset for the changes to take effect.
Call Screening

Call Holding

Busy Greeting

Await Answer Transfer

2 - 372
Unit Basic Tone
1 11 ~ 480/620Hz -13/-13dB
2 0 - No Tone
3 0 - No Tone
4 0 - No Tone
5 0 - No Tone
6 0 - No Tone
7 0 - No Tone
Tone 06
Duration
300ms
300ms
0ms
0ms
0ms
0ms
0ms
Distinctive Ringing, Tones and Flash Patterns
Electra Elite IPK II
Gain Level
32
32