NEC Electra Elite IPK II System User Manual page 483

Electra Elite IPK II
Table 2-25 Service Code Setup, Administrative (for Special Access), Program 11-15
Item
No.
01
Remote Maintenance
02 ACD Access in Dial-In Conversion Table
03 Backup Data Save
This option saves the user's soft key settings (extension
programmed Call Forwards, DND, etc.). This feature should
be used before upgrading the system software.
04
--- Not Used ---
05 System Programming Mode, Log-On
06
Wake on LAN to APSU Unit
07 --- Not Used ---
08 --- Not Used ---
09
Transfer to Incoming Ring Group
10 --- Not Used ---
11 Ethernet Port Reset
12
Extension Data Swap
13 --- Not Used ---
14
Modem Access

11-16-01 Single Digit Service Code Setup – Step Call
Assign the Single Digit (post-dialing) Service Code.

11-16-02 One-Digit Service Code Setup – Barge-In
Set up Item 02 for single digit Barge-In. For example, you can assign Item 02 to use digit 5 for
Barge-In. This allows you to program a function key with an extension number plus the Barge-In
code (i.e., 5). This allows one-touch access to the Barge-In feature for extension.

11-16-03 Single Digit Service Code Setup – Switching of Voice/Signal Call
(Default: 1).

11-16-04 Single Digit Service Code Setup – Intercom Off-Hook Signaling
Assign a one-digit service code to be used for Off-Hook Signaling.

11-16-05 Single Digit Service Code Setup – Camp-On
Customize the 1-digit Service Code used for setting Camp-On.
(default: #)
Flexible System Numbering
Item
Document Revision 4C
Terminals Default
730
760
# # 9
MLT

# #
MLT
 
MLT No Setting
No Setting
MLT, SLT No Setting
MLT, SLT No Setting
MLT, SLT 740
Related
Program
22-04
22-11
11-01-01
10-22
2 - 459