NEC Electra Elite IPK II System User Manual page 753

Electra Elite IPK II

14-05-01 Trunk Group – Trunk Group Number
Program Tie Lines of similar type into the same trunk group. The system uses trunk groups for
outgoing access to Tie Lines (i.e., Service Code 704 + group). Also see Program 34-05-01.
Options:
Trunk group numbers 1~200
Priority: 1~200
(default: All ports in Group 1; Trunk Port 1~200 = Priority 1~200)

14-06-01 Trunk Group Routing – Priority Order Number
When a Tie Line user dials 9, the system uses the routes defined in this program. Refer to
Program 34-03-01.
Options:
Priority Order Number 1~4
0 = Not Specify
1~100 Trunk Groups
1001~1100 (1000 + Route Table No).
[default: Route 1, Order Number 1 =Trunk Group 1;Order Numbers 2~4 = 0; All other routes
(2~100) and Order numbers 1~4 = 0]

20-01-05 System Options – DTMF Receive Active Time
After answering the Tie Line call, the system attaches a DTMF receiver to the Tie Line for this
time (0~64800 seconds).
(default: 10)

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to extensions.
(default: Extension 101 in Class 15 – All others in Class 1)

20-09-01 Class of Service Options (Incoming Call Service) – Second Call for DID/DISA/DIL/E&M
Override
Enable (1)/Disable (0) an extension ability to receive a second call from a DID, DISA, DIL, or Tie
Line caller.
(default: 1)

20-14-01
through
20-14-12 Class of Service Options for DISA/E&M
Enable (1)/Disable (0) the following options for each Tie Line Class of Service (1~15):
01
02
03
04
05
06
07
08
09
10
11
12
Multiple Trunk Types
First Digit Absorption (Delete First Digit Dialed)
Trunk Group Routing/ARS Access
Trunk Group Access
Outgoing System Speed Dial
Operator Calling
Internal Paging
External Paging
Direct Trunk Access
Forced Trunk Disconnect <Not for ISDN T-point>
Call Forward Setting by Remote via DISA
DISA/Tie Trunk Barge-In
Retrieve Park Hold
Document Revision 4C
2 - 729