NEC Electra Elite IPK II System User Manual page 202

Document Revision 4C
6. Dial the Speed Dial bin in which the number is to be stored. If you press Hold, the next available
Speed Dial bin is used. The display shows:
SYS XXXX:
xxxxxxxxxxxxx
If all Speed Dial bins are used, the display shows TABLE IS FULL.

7. Press HOLD. The display shows:
SYS XXXX
-
8. Enter the name to be associated with the stored number.
Use this keypad digit . . .
1
2
3
4
5
6
7
8
9
0

#
CONF
HOLD
2 - 178
Table 2-5 Keys for Entering Names
When you want to. . .
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
Enter characters: D-F, d-f, 3.
Enter characters: G-I, g-i, 4.
Enter characters: J-L, j-l, 5.
Enter characters: M-O, m-o, 6.
Enter characters: P-S, p-s, 7.
Enter characters: T-V, t-v, 8.
Enter characters: W-Z, w-z, 9.
Enter characters:
0 ! " # $ %
Enter characters:
+ , - . / :

# = Accepts an entry (only required if two letters on the same key are needed
- ex: TOM). Pressing # again = Space. (In system programming mode, use
the right arrow Softkey instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
¨
Æ
Á À Â Ã Ç É Ê ì ó
& ' ( ) ô Õ ú ä ö ü
? B E
; < = >
Electra Elite IPK II



S ¢ £
Caller ID