NEC Electra Elite IPK II System User Manual page 371

Electra Elite IPK II

22-01-11 System Options for Incoming Calls – VRS Waiting Message Interval Time
Set up the duration time between announcing the VRS Waiting Message for Auto – Attendant &
Queuing. The message is repeatedly sent out during the specified time (0~64800 seconds).

22-02-01 Incoming Call Trunk Setup
For DISA operation, set the trunk service type to 2. You can have a different service type for
each Night Service mode.

22-04-01 Incoming Extension Ring Group Assignment
Assign the extensions that should receive the overflow. Set the ringing in Program 22-06.
0 = Trunks Do Not Ring (just flash line keys)
1 = Trunks Ring

25-01-01 VRS/DISA Line Basic Data Setup – VRS/DISA Dial-In Mode
Select whether the DISA trunk uses the Extension number/Service code specify (0) or the Dial
Conversion Table (1). Default is 0.

25-01-02 VRS/DISA Line Basic Data Setup – DISA User ID
Select whether or not the DISA User ID is used.
0 = Off
1 = On (default

25-01-03 VRS/DISA Line Basic Data Setup – VRS/DISA Transfer Alarm
Select whether or not the DISA transfer alarm is used.
0 = Normal (default)
1 = Alarm

25-02-01 VRS/DISA VRS Message
Assign the source and VRS message number used as the Automated Attendant Message for
each trunk (001~200) which is assigned as a VRS/DISA:
0 = No Message (default)
1 = VRS (VRS Message Number = 01~48)
2 = ACI (ACI Group Number = 01~16)
3 = SLT (Department Group Number = 01~64)

25-03-01 VRS/DISA Transfer Ring Group With Incorrect Dialing
Set the operating mode of each DISA trunk. This sets what happens to the call when the DISA
caller dials incorrectly. The call can either disconnect (0), transfer to an alternate ring group
destination, or transfer to In-Skin/External Voice Mail, or Centralized Voice Mail. Default is 0.
Ring Groups:
31~100
102 = In-Skin/External Voice Mail
103 = Centralized Voice Mail
Direct Inward System Access (DISA)
Document Revision 4C
2 - 347