NEC Electra Elite IPK II System User Manual page 114

Document Revision 4C

26-03-01 ARS Dial Treatments – Treatment Code
Assign the Dial Treatments (1~15) for automatic ARS dialing translation. Assign Dial Treatments
to Service Numbers (Trunk Groups) in Program 26-02. The ARS Dial Treatment options are:
3 - Delete the NPA if dialed as part of the initial call. This requires at least eight digits in the ARS

table (Program 26-02-01).
2 - Delete the leading digit if dialed as part of the initial call. This requires at least eight digits in

the ARS table (Program 26-02-01).
1 - Add a leading 1 if not dialed as part of the initial call. This requires at least eight digits in the

ARS table (Program 26-02-01).
INPA - Insert the NPA specified by NPA.

DNN - Outdial the NN number of digits or execute the code that follows. For example, D041234

out-dials 124. Valid entries are 0~9,
counts as a digit. So for example, if a P was added for a pause, the entry would look like:
D05P1234. This Dial Treatment can only be added from telephone programming.
Wnn - Wait nn seconds.

P - Pause in analog trunk.

R - Redial the initially dialed number, including any modifications.

E - End of Dial Treatment. All Dial Treatments must end with the E code.

X - When ARS is enabled, X must be entered in the Dial Treatment for the system to output the

extension number of the call's originator to the black box for the E911 feature.

26-04-01 ARS Class of Service
Set an extension ARS Class of Service (0~16). Automatic Route Selection uses ARS Class of
Service when determining how to route an extension calls.

26-11-01 Transit Network ID Table – Transmit Network ID (Carrier ID)
Enter the Transit Network Selection information element to be added to an ARS call using an
ISDN trunk. This information element identifies a requested transit network.

44-01-01 System Options for ARS/F-Route – ARS/F-Route Time Schedule
Select whether the ARS/F-Route feature should use the time schedule (0=not used, 1=used). If
this option is set to 0, the F-Route table selected is determined only by the digits dialed without
any relation to the day or time of the call. If this option is set to 1, the system first refers to
Program 44-10. If there is a match, the pattern defined in that program is used. If not, the
F-Route pattern in Program 44-09 and time setting in Program 44-08 are used.

44-02-01 Dial Analysis Table for ARS/F-Route Access – Dial
Set the Dial digits for the Pre-Transaction Table for selecting ARS/F-Route (eight digits max:
1~9, 0

44-02-02 Dial Analysis Table for ARS/F-Route Access – Service Type
Set the Service Type (0~3) for the Pre-Transaction Table for selecting ARS/F-Route.
0 = No Setting
1 = Extension Call
2 = ARS/F-Route Table
3 = Dial Extension Analyze Table
2 - 90
#, @). To enter a wild card/don't care digit, press Line Key 1 to enter @.

# ,
, Wnn (wait nn seconds) and P (pause). Each digits code

Electra Elite IPK II
Automatic Route Selection