NEC Electra Elite IPK II System User Manual page 814

Document Revision 4C

14-04-01 Behind PBX Setup – Type of Connection
For each PBX trunk port, enter 1. Make a separate entry for each Night Service mode.

21-04-01 Toll Restriction Class for Extensions
Assign a Toll Restriction Class (1~15) to each extension. (default: 2)

21-05-12 Toll Restriction Class – PBX Call Restriction
For each Toll Restriction Class, enter 1 to restrict calls on the PBX trunk to outside calls only.
Enter 0 to allow users to dial PBX extensions. (default: 0)

21-06-08 Toll Restriction Table Data Setup – PBX Access Code
Enter the system PBX access codes. The system can have up to four groups of codes. A code
can have one or two digits. Valid entries are 0~9, # and
digit. If using Account Codes, do not use
Operation
To place a call over a PBX trunk:
1. At multiline terminal, press Speaker and dial 704.
- OR -
At single line telephone, lift the handset and dial 704.
2. Dial PBX trunk group number (1~9 or 001~100).
3. Dial PBX access code and number.
- OR -
1. At the multiline terminal only, press PBX trunk group key (PRG 15-07 or SC 752:
2. Dial PBX access code and number.
- OR -
1. At the multiline terminal, press Speaker and dial 9.
- OR -
At the single line telephone, lift the handset and dial 9.
2. Dial the PBX access code and number.
- OR -
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 9.
#
3. Dial the PBX trunk number (e.g., 005 for line 5).
2 - 790
. Use Line Key 1 as a "don't care"

in the PBX Access Code.

Electra Elite IPK II
02 + group).

PBX Compatibility