NEC Electra Elite IPK II System User Manual page 71

Electra Elite IPK II
Physical Ports and Software Ports
Each PGD(2)-U10 ADP consists of a physical port for connection to the telephone system and two logical
ports. For programming, the ports are also called software ports. The physical port connects to a station
position on a ESI ETU. During installation, the first PGD(2)-U10 ADP you set up is physical port 1; the
second PGD(2)-U10 ADP is physical port 2, etc. Each PGD(2)-U10 ADP has two software ports, which
are numbered independently of the physical ports. Normally, the first PGD(2)-U10 ADP set up has
software ports 1~2; the second PGD(2)-U10 ADP has software ports 3~4, etc. There are a total of 96
software ports (48 PGD(2)-U10 ADPs x 2 ports each). During programming, you assign ACI extension
numbers and Department Group options to PGD(2)-U10 ADP software ports, not physical ports. During
installation, you connect equipment to the jacks on the PGD(2)-U10 ADP that correspond to the software
port. Refer to the Electra Elite IPK II System Hardware Manual for installation details.
Conditions
ACD agents who are logged on can be recorded.

ACI software ports cannot be Background Music music sources.

An extension cannot have Hotline keys for ACI software ports. Music on Hold ACI software

ports can be Music on Hold music sources.
An extension can have One-Touch Keys for ACI software ports. The gives the extension

user:
One-Touch access to external music

One-Touch External Paging

One-Touch loud ringer control

ACI software ports can provide External Paging with control, independent of the External

Paging circuits on the CPUII ETU. The PGD(2)-U10 ADP can be connected only to an
ESIB(8)-U20 ETU. If the PGD(2)-U10 ADP is connected to an ESIE(8)-U20 ETU, the
PGD(2)-U10 ADP is NOT recognized.
When an ESIB(8)-U20 ETU has an ESIE(8)-U20 ETU installed [ESIB/E(16)], the

PGD(2)-U10 ADP has both channels available for Paging, MOH, External Ringers, and
Door Box according to strapping on ports 1~8. The corresponding port on the ESIE(8)-U20
ETU does not support a station or other hardware (it is used by the PGD(2)-U10 ADP for
channel 2).
When an ESIB(8)-U20 ETU is installed without an ESIE(8)-U20 ETU installed, a

PGD(2)-U10 ADP installed on ports 1~8 is recognized, but only Channel 1 on the
PGD(2)-U10 ADP is supported. Channel 2 is not available.
ESIE(8)-U10 ETUs and ESIE(8)-U10 ETUs do not support the PGD(2)-U10 ADP.

Analog Communications Interface (ACI)
Document Revision 4C
2 - 47