NEC Electra Elite IPK II System User Manual page 757

Electra Elite IPK II

81-11-10 Tie Line Initial Setup – Wink/Delay Signal Detect Timeout Selection
Specify a maximum time for receiving an acknowledgment signal from a distant system before
sending a busy tone.
(default: 7 seconds)

81-11-11 Tie Line Initial Setup – Disconnect Recognition Time Selection
Specify the minimum time before a disconnected circuit can be accessed again.
[default: 3 (0.3 seconds)]

81-11-12 Tie Line Initial Setup – Automatic Release Signal Detection Selection
Specify the signal detection time for release of a Tie Line after a disconnect signal is received
from the distant Central Office or PBX.
[default: 7 (350 ms)]
Operation
None
Multiple Trunk Types
Document Revision 4C
2 - 733