NEC Electra Elite IPK II System User Manual page 929

Electra Elite IPK II
Use this keypad digit . . .
#
CONF
HOLD
7. Press Hold.
8. Press Speaker to hang up or repeat steps 3~7 to program another System or Group Speed Dial
bin.
To dial a System Speed Dialing number:
1. Go off-hook.
2. Press Redial.
3. Dial the System Speed Dialing storage code.
Unless you preselect, Trunk Group Routing selects the trunk for the call. The system may optionally select a

specific Trunk Group for the call.
If you have a DSS Console, you may be able to press a DSS Console key to chain to a stored number.

To store a System Speed Dialing number under a Programmable Function Key:
1. At multiline terminal, press Speaker.
2. Dial 751.
3. Press the key where the number is to be stored.
4. Dial 27.
5. Dial System Speed Dial Bin number to put under the key.
6. Press Speaker to hang up.
To dial a System Speed Dialing number under a Programmable Function Key:
1. At the multiline terminal, press Speaker.
2. Press the key, which has the stored number to be dialed.
The number seizes an outside line and dials out.

Speed Dial – System/Group/Station
Table 2-33 Keys for Entering Names
When you want to. . .
# = Accepts an entry (only required if two letters on the same key are needed – ex:
TOM). Pressing # again = Space. (In system programming mode, use the right
arrow Softkey instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Document Revision 4C
2 - 905