NEC Electra Elite IPK II System User Manual page 735

Electra Elite IPK II

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.

20-13-07 Class of Service Options (Supplementary Service) – Message Waiting
Enable (1)/Disable (0) an extension user ability to leave Messages Waiting.

24-02-05 System Options for Transfer – Message Wait Ring Interval Time
For single line telephones without message waiting lamps, this determines the time between
intermittent ringing. If this time is set to 0, the system rings once.

80-01-01 Service Tone Setup – Repeat Count
Set repeat count for tone 16 Lockout, default = 0 (endless).
Refer to

80-01-02 Service Tone Setup – Basic Tone Number
(Default: 0).
Refer to

80-01-48 Service Tone Setup – Voice Mail Message Waiting, Special Dial
If the default tone is not acceptable for the Message Wait Dial Tone, a new tone can be
assigned.
Operation
To leave a Message Waiting:
1. Call busy or unanswered extension.
2. Dial 0 or press the Message Waiting key (PRG 15-07 or SC 751: 38)
3. Hang up.
With multiline terminal telephones, the Message Waiting LED lights.

To answer a Message Waiting:
 When you have a message, your Message Waiting LED flashes fast for multiline terminals.
1. At the multiline terminal, press Speaker and dial
- OR -
Press the Message Waiting key (PRG 15-07 or SC 751: 38).
- OR -
At the single line telephone, lift the handset and dial
If the called extension does not answer, dial 0 or press your Message Waiting key to automatically leave them a

message.
Normally, your Message Waiting LED goes out. If it continues to flash, you have new messages in your Voice

Mail mailbox or a new General Message. Go to To check your messages below.
Message Waiting
Table 2-26 Service Tone Setup, Program 80-01-01 on page
Table 2-27 Service Tone Setup, Program 80-01-02 on page
0.

0.

Document Revision 4C
2-476.
2-480.
2 - 711