NEC Electra Elite IPK II System User Manual page 373

Electra Elite IPK II

25-07-09 System Timers for VRS/DISA – DISA Internal Paging Time
This is the maximum time for an Internal Page placed by a DISA caller. If the Page continues
longer than this time (0~64800 seconds), the system terminates the DISA call. Default is 30.

25-07-10 System Timers for VRS/DISA – DISA External Paging Time
This is the maximum time an External Page is placed by a DISA caller. If the Page continues
longer than this time (0~64800 seconds), the system terminates the DISA call. Default is 30.

25-07-13 System Timers for VRS/DISA – VRS/DISA Busy Tone Interval
If a DISA caller dials a busy extension (and Program 25-04 = 0), the system plays busy tone for
this time (0~64800 seconds) before disconnecting. Default is 5.

25-08-01 DISA User ID Setup – Password
For each DISA user, set the 6-digit password. Default is No Setting.

25-09-01 Class of Service for DISA Users
Assign a DISA Class of Service for each user. The DISA Class of Service cannot be 0. You
cannot use the PRG 20-XX-XX and PRG 42-XX-XX programs to assign Class of Service to
DISA trunks (15 users, with one password and DISA Class of Service 1~15 for each user).
Default is 1.

25-10-01 Trunk Group Routing for DISA
Assign the Trunk Group Route chosen when a user places a DISA call into the system and dials
9. Set Trunk Group Routing in Program 14-06. If the system has ARS, dialing 9 accesses ARS.
The route chosen is based on the DISA Class of Service, which is determined by the password
the caller dials. Default is 1.
Trunk Group Routes: 1~100

25-11-01 DISA Toll Restriction Class
If the system uses Toll Restriction, enter a Toll Restriction Class (1~15) for each DISA user
(1~15). The system uses the Toll Restriction Class you enter in Program 21-05. The Toll
Restriction Class assigned to a DISA call is based on the DISA Class of Service, which is
determined by the password the caller dials. You cannot use Program 21-04 to assign Toll
Restriction to DISA trunks. Default is 2.

25-12-01 Alternate Trunk Group Routing for DISA
Assign the trunk route that DISA Callers access if they dial the Alternate Trunk Route Access
Code. Refer to
Alternate Trunk Route Access. Default is 1.
Route Table Number: 0~100 (0 = No Setting)
 The Continue and Disconnect codes are set in PRG 20-28 and apply to both DISA and Tandem Trunk calls.
Direct Inward System Access (DISA)
Central Office Calls, Placing on page 2-195
Document Revision 4C
for more information on setting up
2 - 349