Central Office Calls, Placing - NEC Xen Topaz Features And Specifications Manual

NEC Business Solutions Ltd

Central Office Calls, Placing

• Description
The system provides flexibility in the way each extension user can place outgoing trunk
calls. This lets you Customise the call placing options to meet site requirements and
each individual's needs.
A user can place a call by:
Conditions
None
Default Setting
Enabled.
• Programming
Chapter 4 - 104
•
Pressing Line Keys or "Loop Keys"
•
Pressing a Trunk Group (i.e., loop) key
•
Pressing a Trunk Group Routing (dial 0) key
•
Dialling a code for a specific trunk (805 + the trunk number)
•
Dialling a code for a Trunk Group (804 + group number)
•
Dialling a code for Trunk Group Routing or ARS (0)
•
Dialling an Alternate Trunk Route Access Code (which you must define)
10-03-03: PCB Setup - Transmit CODEC Gain Type
CustomiseCustomise the transmit and receive levels of the CODEC
Gain Types for single line telephones.
10-03-04: PCB Setup - Receive CODEC Gain Type
Customise the transmit and receive levels of the CODEC Gain Types for
single line telephones.
11-01-01: System Numbering
Set up a Service Code for Alternate Trunk Route Access.
11-09-01: Trunk Access Code
If required, change the single-digit Trunk Access Code (normally 0). If
you change this code, you must also review the settings in 11-01 for the
new code selected.
11-09-02: Trunk Access Code - Alternate Trunk Route Access Code
Assign the Service Code set up in 11-01 for Alternate Trunk Route
Access.
11-12-01: Service Code Setup (for Service Access)
To simplify placing calls, assign function keys for placing trunk calls:
Trunk Group Routing/dial 0 keys (code 804).
14-01-01: Basic Trunk Data Setup - Trunk Name
To make identifying calls easier, assign a name to each trunk.
14-01-02: Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03: Basic Trunk Data Setup - Receive CODEC Gain Type
XEN Topaz
Features