Isuzu 1999 RODEO Workshop Manual page 619

Hide thumbs Also See for 1999 RODEO:

Table of Contents

STARTING AND CHARGING SYSTEM (X22SE 2.2L)

Continuity of Series Coil

Check for continuity between terminals S and M.

Replace, if there is no continuity (i.e., coil is

disconnected).

Continuity of Contacts

With the plunger faced downward, push down the

magnetic switch. In this state, check for continuity

between terminals B and M. Replace, if there is no

continuity (i.e., contacts are faulty).

Check if the pinion rotates smoothly in drive direction by

hand, or if it is locked when it is rotated in reverse. If not,

replace the pinion.

Characteristic Test

For easily confirming the characteristics, conduct the

noload test as follows:

Rating as short as 30 seconds requires rapid testing.

Fix the starter on the test bench, and wire as shown in

illustration. When the switch is closed, the current flows

and the starter runs under no load. At this time, measure

current, voltage and speed to check if they satisfy the

(1) Volt Meter

(2) Revolution Indicator

Show Quick Links

Chapters

Table of Contents

Do you have a question about the 1999 RODEO and is the answer not in the manual?