Isuzu 1999 RODEO Workshop Manual page 1010

5. Remove the retaining bolt and sensor from the engine
block.
NOTE: Use caution to avoid any hot oil that might drip
out.
Installation Procedure
1. Install the crank shaft position sensor to its position.
2. Install and tighten the mounting bolt. Refer to Engine
Mechanical Section.
RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
0013
0013
3. Reinstall the power steering pump and bracket to the
engine.
4. Reinstall the accessory drive belt.
5. Connect the negative battery cable.
IMPORTANT: PCM must re–learn Crankshaft Position
when the CKP sensor is replaced. Refer to CKP sensor
learn mode on the Tech 2, or Tooth Error Correction in the
Service Manual.
6E1–383
014RX006
014RX003