Cylinder Head; Removal; Installation - Isuzu 1999 RODEO Workshop Manual

6A–36 ENGINE MECHANICAL (6VD1 3.2L)

Removal

1. Remove engine hood.
2. Disconnect battery ground cable.
3. Drain radiator coolant.
4. Drain engine oil.
5. Remove crankshaft pulley.
f Refer to removal procedure for Crankshaft Pulley in
this manual.
6. Remove timing belt.
f Refer to removal procedure for Timing Belt in this
manual.
7. Remove cylinder head cover LH.
f Refer to removal procedure for Cylinder Head
Cover LH in this manual.
8. Remove cylinder head cover RH.
f Refer to removal procedure for Cylinder Head
Cover RH in this manual.
9. Remove common chamber.
f Refer to removal procedure for Common Chamber
in this manual.
10. Remove cylinder head assembly.
1. Loosen eights bolts for tight cylinder head.
2. Remove cylinder head assembly.
Legend

(1) Cylinder Head

(2) Cylinder Head Bolt
(3) Camshaft

Installation

1. Install cylinder head assembly to cylinder block.
1. Put cylinder head gasket on the cylinder block.
Cylinder Head
NOTE: There is discrimination mark "R" for right bank
and "L" for left bank on the cylinder head gasket as shown
in the illustration.
Do not reuse cylinder head gasket.
2. Align dowel pin hole to dowel pin on the cylinder
block.
3. Tighten two bolts temporarily by hand to prevent
the cylinder head assembly from moving.
4. Using J-24239-01 cylinder head bolt wrench,
tighten bolts in numerical order as shown in the
illustration to the specified torque.
NOTE: Do not reuse cylinder head bolts.
Do not apply any lubricant to the cylinder head bolts.
Torque :
Temporary : 29 N·m (21 lb ft)
Final : 64 N·m (47 lb ft)
014RW028
011RW005
014RW029