Isuzu 1999 RODEO Workshop Manual page 166

3. Install plate.
4. Install nut and tighten fulcrum pin nut finger–tight.
NOTE: Torque fulcrum pin nut after adjusting buffer
clearance.
Buffer clearance: 22 mm (0.87 in)
Torque: 108 N·m (80 lb ft)
5. Install upper control arm assembly with the fulcrum
pin projections turned inward.
901RW159
Legend
(1) Projection
(2) Outward
6. Install the caster shims(2) between the chassis frame
and fulcrum pin.
7. Install the camber shims(1) between the chassis
frame and fulcrum pin.
450RS012
8. Install nut assembly.
9. Install bolt and plate, then tighten the bolt to the
specified torque.
Torque: 152 N·m (112 lb ft)
10. Install upper ball joint and tighten it to the specified
torque.
Torque: 57 N·m (42 lb ft)
11. Install nut and cotter pin then tighten the nut to the
specified torque, with just enough additional torque to
align cotter pin holes. Install new cotter pin.
Torque: 98 N·m (72 lb ft)
12. Install speed sensor cable.
FRONT SUSPENSION 3C–15
450RS013
450RS014