Isuzu 1999 RODEO Workshop Manual page 311

4C–22
DRIVE SHAFT SYSTEM
Sleeve Condition
Check and see that there is not wear damage, or cracking
in the sleeve.
NOTE: Close inspection of the groove and inner gear are
required because those are important parts.
Sleeve Function
Operate the sleeve with the inner shaft combined with the
clutch gear and if smoothlessness is felt, replace the
sleeve.
NOTE: Gear oil should be applied to the contact surface
of gear.
Check the width of sleeve center groove.
Limit: 7.1 mm (1.28 in)
Clutch Gear Condition
Check and see that there is not wear, damage, crack, or
any other abnormality in the clutch gear.
Clutch Gear Function
If there is an abnormality such as roughness when
operated in combination with sleeve, replace the clutch
gear.
412RW011
NOTE: When inspecting, gear oil should be applied to the
contact surface of gear.
Clutch Gear Journal Diameter
Make sure of the size illustrated.
Limit: 36.98 mm (1.456 in)
412RW022
412RW010
412RW009