Disassembly - Isuzu 1999 RODEO Workshop Manual

Disassembly

Legend
(1) Sleeve Yoke
(2) Clamp
1. Lay the shaft horizontally on a bench and secure.
2. Indicate the original assembled position (1) by
marking the phasing of the shaft prior to disassembly.
(3) Boot
(4) Clamp
(5) Tube Assembly
3. Using the flat blade of a screwdriver, pry the loose end
of the boot clamp upwards and away from the
propeller shaft boot. Be careful not to damage the
boot.
4. When boot clamps becomes loose, remove by hand.
5. Repeat for the other boot clamp.
6. Remove the slip yoke assembly from the driveshaft,
by securing the boot with one hand and pulling on the
slip yoke.
7. Remove the boot from the shaft assembly.
401RW037
DRIVE SHAFT SYSTEM
4C–33
401RW032