Stabilizer Bar 3C-6; Stabilizer Bar And Associated Parts 3C-6; Removal; Installation - Isuzu 1999 RODEO Workshop Manual

FRONT SUSPENSION
3C–6
Stabilizer Bar and Associated Parts
Legend
(1) Rubber Bushing
(2) Bracket

Removal

1. Raise the vehicle and support the frame with suitable
safety stands.
2. Remove the stone guard.
3. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
4. Remove nut.
CAUTION: Be careful not to break the ball joint boot.
5. Remove link.
6. Remove bracket.
7. Remove stabilizer bar.
8. Remove rubber bushing.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts :
Stabilizer Bar
(3) Link
(4) Nut
(5) Stabilizer Bar
f Stabilizer bar
f Rubber bushing
f Link ball joint

Installation

1. Install rubber bushing.
2. Install stabilizer bar.
3. Install bracket, then tighten it to the specified torque.
Torque: 25 N·m (18 lb ft)
4. Install link.
5. Install nut, then tighten it to the specified torque.
Torque: 50 N·m (37 lb ft)
410RW007