Isuzu 1999 RODEO Workshop Manual page 331

4C–42
DRIVE SHAFT SYSTEM
1. Apply alignment marks on the yokes of the universal
joint, then remove the snap ring.
If the snap ring is stuck in position, remove paint from
the hole in the yoke or tap around the edge of the
bearing lightly with a soft drift.
2. Set the yoke in the arbor press with a piece of tube
stock beneath it.
Place a solid plug on the upper bearing and press it
through to release the lower bearing.
401RW024
3. If the bearing will not pull out by hand after pressing,
tap the base of the lug near the bearing to dislodge it.
4. To remove the opposite bearing, turn the yoke over
and straighten the spider in the open spider hole.
Then carefully press on the end of the spider so the
remaining bearing moves straight out of the bearing
spider hole. If the spider or bearing are cocked, the
bearing will score the walls of the spider hole and ruin
it.
401RW025
401RW027
401RW026