Manifold Absolute Pressure (Map) Sensor - Isuzu 1999 RODEO Workshop Manual

4. Remove the sensor from intake air duct by using a
rocking motion while pulling the sensor.
Installation Procedure
1. Install the IAT sensor into intake air duct. Make sure
the sensoris pushed all the way into the intake air
duct.
2. Connect electrical connector.
3. Connect the negative battery cable.
RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
0018
014RX011
Manifold Absolute Pressure
(MAP) Sensor
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector from the sensor.
(The MAP sensoris located on the intake manifold
behind throttle body.)
3. Remove a mounting bolt securing the sensor to the
manifold.
4. Remove the sensor from the intake manifold using
rocking motion while pulling the sensor.
Installation Procedure
1. Push MAP sensor into the manifold. Make sure the
sensor is pushed always into its position.
2. Install a mounting bolts and tighten.
3. Connect electrical connector.
4. Connect the negative battery cable.
6E1–387
014RX012
014RX013