Oil Pressure Switch; Fuel Metering System Accelerator Cable Assembly - Isuzu 1999 RODEO Workshop Manual

6E1–398 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION

Oil Pressure Switch

Removal Procedure
1. Disconnect battery negative cable.
2. Disconnect electrical connector at Oil Pressure
Switch.
3. Unscrew Oil Pressure Switch from Oil Filter Mounting
Housing.
Installation Procedure
1. Install Oil Pressure Switch into Oil Filter Mounting
Housing and tighten.
2. Connect electrical connector.
3. Connect battery negative cable.
FUEL METERING SYSTEM Ac-
celerator Cable Assembly
014RX030
Removal Procedure
1. Loosen the adjusting nut on the cable bracket
mounting on the throttle body.
2. Remove the cable clip from holding bracket.
014RX031
014RX028
014RX026