Removal; Installation - Isuzu 1999 RODEO Workshop Manual

Removal

1. Remove two bolts and remove ignition cable cover (1)
from cylinder head cover (3).
2. Disconnect ignition cable and remove spark plag (2).
3. Disconnect ignition cable from ignition plug.
4. Disconnect camshaft angle sensor harness and
crankshaft angle sensor harness from behind
generator.
5. Remove four bolts and remove the crankshaft pulley.
6. Remove timing belt front cover.
7. Loose fixing bolt of timing belt rear cover, then
remove the camshaft angle sensor.
8. Remove ten cylinder head cover fixing bolts and
remove the cylinder head cover.
ENGINE MECHANICAL (X22SE 2.2L)

Installation

1. Install the camshaft angle sensor and tighten timing
rear cover bolt.
Torque: 8 N·m (5.9 lb ft)
2. Install the cylinder head cover and tighten bolts to the
specified torque.
Torque: 8 N·m (5.9 lb ft)
3. Install the timing belt front cover then tighten fixing
bolts to the specified torque.
020RW014
Torque: 6 N·m (4.4 lb ft)
4. Install the crankshaft pulley, tighten fixing bolts to the
specified torque.
Torque: 20 N·m (14 lb ft)
020RW012
6A–61
020RW012
020RW014