Isuzu 1999 RODEO Workshop Manual page 127

3. Install the vanes to roter with curved face in contact
with the inner wall of cam.
4. Install roter and vanes to cam.
5. Install pin to front housing.
6. Install two new O-rings to front housing. Be sure to
discard used O-ring.
7. Install side plate.
CAUTION: When installing side plate, be careful not
to damage its inner surface. Damaged side plate may
cause poor pump performance, pump seizure or oil
leakage.
8. Install pump cartridge assembly to front housing.
9. Install snap ring to shaft end.
10. Install rear housing with a new O-ring. Be sure to
discard used O-ring. Then install bolt and tighten it to
specified torque.
Torque: 24 N·m (17 lb ft)
11. Install suction pipe with a new O-ring. Be sure to
discard used O-ring. Then install bolt and tighten it to
specified torque.
Torque: 10 N·m (87 lb in)
12. Install relief valve and spring.
13. Install connector with a new O-ring.
discard used O-ring. Tighten the connector to
specified torque.
Torque: 59 N·m (43 lb ft)
14. Install pressure switch assembly and tighten it to
specified torque.
Torque: 18 N·m (13 lb ft)
POWER–ASSISTED STEERING SYSTEM
442RS005
Be sure to
2A–25