2. Use tool J 28742–A or the equivalent to remove the
pin and the sleeve terminals. Push on J 28742–A to
release.
NOTE: Do not use an ordinary pick or the terminal may
be bent or deformed. Unlike standard blade terminals,
these terminals cannot be straightened after they have
been improperly bent.
3. Cut the wire immediately behind the cable seal.
RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
071
072
Installation Procedure
Make certain the connectors are properly seated and all
of the sealing rings are in place when you reconnect the
leads. The secondary lock hinge provides a backup
locking feature for the connector. The secondary lock
hinge is used for added reliability. This flap should retain
the terminals even if the small terminal lock tangs are not
positioned properly.
Do not replace the Weather–Pack connections with
standard connections. Read the instructions provided
with
the
Weather–Pack
packages.
1. Replace the terminal.
2. Slip the new seal onto the wire.
3. Strip 5 mm (0.2") of insulation from the wire.
4. Crimp the terminal over the wire and the seal.
5. Push the terminal and the connector to engage the
locking tangs.
6. Close the secondary locking hinge.
6E1–423
connector
and
terminal
073