Isuzu 1999 RODEO Workshop Manual page 851

6E1–224 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
DTC P0341 – CMP Sensor Circuit Range/Performance (Cont'd)
Step
9 Repair the open circuit.
Is the repair complete?
10 1. Ignition ON.
2. Use a DVM to measure at the CMP connector
between the battery + and the CMP ground wire.
Does the DVM indicate the specified value?
11 Repair the open ground wire.
Is the repair complete?
12 Use an ohmmeter to check continuity of the signal wire
between the CMP and the PCM.
Was there an open circuit?
13 Repair the open signal wire.
Is the action complete?
14 1. Ignition ON.
2. Check the signal wire for a short to ground or a short
to voltage.
Was a problem found?
15 Repair the signal circuit problem.
Is the action complete?
16 Replace the CMP Sensor.
Is the action complete?
Action Value(s) Yes
— Verify repair
Go to Step
B+
12
— Verify repair
Go to Step
— 13
— Verify repair
Go to Step
— 15
— Verify repair
— Verify repair
No
—
Go to Step
11
—
Go to Step
14
—
Go to Step
16
—
—