Timing Belt; Removal - Isuzu 1999 RODEO Workshop Manual

6A–28 ENGINE MECHANICAL (X22SE 2.2L)
31. Install exhaust front pipe to exhaust manifold and
tighten four nuts to the specified torque.
Torque: 25 N·m (18 lb ft)
32. Install radiator upper hose to engine.
33. Move drive belt tensioner to loose side using wrench
then install the drive belt to normal position.

Removal

1. Disconnect battery ground cable.
2. Move drive belt tensioner to loose side using wrench
then remove drive belt.
34. Install intake air duct bracket to cylinder head.
35. Install air intake duct assembly with air cleaner cover
to throttle body and tighten nut to the air intake duct
027RW005 bracket then tighten hose clamp.
Torque
7 N·m (5.1 lb ft) for nut
3 N·m (2.2 lb ft) for hose clamp bolt
36. Install PCV hose to air intake duct.
37. Connect connector of intake air temperature sensor
on intake air duct.
38. Connect battery ground cable.
39. Fill engine coolant to full level in the engine coolant
reservoir tank.

Timing Belt

3. Remove engine harness cover and disconnect three
connectors from left rear side of engine compartment.
4. Remove four bolts and remove crankshaft pulley.
033RW001
033RW001
020RW014