Isuzu 1999 RODEO Workshop Manual page 561

6A–52 ENGINE MECHANICAL (X22SE 2.2L)
f Tighten the bolts in 3 steps:
1st step: 35 N·m (25 lb ft)
2nd step: 45°
3rd step: 15°
5. Install the balance unit assembly and tighten the bolts
in 2 steps:
1st step: 20 N·m (14 lb ft)
2nd step: 45°
Refer to the "Balance Unit Assembly" section of this
manual.
6. Install oil pump assembly (5), refer to "Oil Pump" in
this manual.
7. Install oil strainer.
Torque: 8 N·m (5.8 lb ft)
8. Install oil pan support and tighten the bolts to the
specified torque.
Torque: 20 N·m (14 lb ft)
9. Install oil pan.
1. Completely remove all residual sealant, lubricant
and moisture from the sealing surfaces. The
surfaces must be perfectly dry.
2. Apply a correct width bead of sealant (TB–1207C
or its equivalent) to the contact surfaces of the oil
pan. There must be no gaps in the bead.
3. The oil pan support must be installed within 5
minutes after sealant application.
4. Tighten the bolts in to steps.
1st step: 8 N·m (5.8 lb ft)
2nd step: 30°
10. Install cylinder head assembly, refer to "Cylinder
Head" in this manual.