9. Remove back plate.
10. Remove lower ball joint by using remover J–29107.
CAUTION: Be careful not to damage the ball joint
boot.
11. Remove upper ball joint by using remover J–36831.
CAUTION: Be careful not to damage the ball joint
boot.
12. Remove knuckle assembly.
13. Remove oil seal (Except 2WD model).
14. Remove washer (Except 2WD model).
15. Remove needle bearing by using remover J–23907
(Except 2WD model).
Inspection and Repair
901RW163
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts:
f Knuckle
f Knuckle arm
f Needle bearing
f Thrust washer
Installation
1. Apply appropriate amount of multipurpose type
grease to the new bearing (Approx. 5 g) and install
needle bearing by using installer J–36838 and
J–8092 (Except 2WD model).
901RW162
FRONT SUSPENSION
3C–11
901RW044
901RW045