Camshaft Position (Cmp) Sensor; Removal Procedure; Installation Procedure - Isuzu 1999 RODEO Workshop Manual

Camshaft Position (CMP)
Sensor

Removal Procedure

1. Disconnect the negative battery cable.
2. Remove spark plug cover on top of valve cover by
removing four retaining bolts.
3. Disconnect electrical connector from the sensor.
4. Remove drive belt. Refer to Engine Mechanical
Section.
5. Remove top harness cover installed on timing belt
cover by removing a retaining screw.
6. Remove the retaining bolts holding crankshaft pulley,
and pull crankshaft pulley while wiggling. Refer to
Engine Mechanical Section.
7. Remove the retaining screws for timing belt cover and
timing belt cover.
RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION
014RX003
014RX004
8. Remove the retaining bolt for the sensor and pull up
camshaft position sensor.

Installation Procedure

1. Insert camshaft position sensor in position.
2. Install retaining bolt.
3. Install the timing belt cover and the retaining screws.
4. Install the crank shaft pulley and the mounting bolts.
Holes for mounting bolts are off the pitch. The pulley
can be mounted only one way to install all mounting
bolts. Tighten the bolts. Refer to Engine Mechanical
section.
6E1–381
014RX005
014RX007