Cylinder Head Assembly; Removal - Isuzu 1999 RODEO Workshop Manual

6A–22 ENGINE MECHANICAL (X22SE 2.2L)

Removal

1. Disconnect battery ground cable.
2. Disconnect connector of intake air temperature
sensor from intake air duct.
3. Remove PCV hose from air intake duct.
4. Remove nut from air intake duct bracket and loosen
hose clamp on throttle body. Remove air intake duct
assembly with air cleaner cover.
5. Remove intake air duct bracket from cylinder head.
6. Drain engine coolant.
7. Move drive belt tensioner to loose side using wrench
then remove drive belt.
8. Remove radiator upper hose from engine side.
9. Remove four nuts of exhaust front pipe.
10. Remove three bolts from generator bracket then
remove the generator with brackets.
11. Disconnect crankshaft angle sensor connector.
12. Disconnect knock sensor connector.

Cylinder Head Assembly

13. Remove heater hose from adapter side.
14. Remove heater hose from water pipe side.
15. Remove water hose between water pipe and throttle
16. Remove fuel pipe joint eye bolts from fuel rail
17. Disconnect connector for evaporation valve.
18. Remove canister hose.
19. Remove fixing nut of intake manifold stay from
033RW001
20. Remove two bolts from intake manifold for water pipe
21. Remove engine harness cover and disconnect three
22. Disconnect connector for power steering pump
065RW025
23. Remove four bolts and remove crankshaft pulley.
body.
assembly and remove fuel pipe bracket with electric
ground cable.
cylinder block side.
support and remove cylinder head assembly.
connectors from chassis harness on left rear side
engine compartment.
pressure switch.
042RW001
025RW002