Removal; Installation - Isuzu 1999 RODEO Workshop Manual

Shock Absorber and Associated Parts
Legend
(1) Nut
(2) Rubber Bushing and Washer

Removal

1. Raise the vehicle and support it with suitable safety
stands.
2. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
3. Remove bolt and nut.
4. Remove nut.
5. Remove rubber bushing and washer.
6. Remove shock absorber.
7. Remove rubber bushing and washer.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts :
f Shock absorber
f Rubber bushing
Shock Absorber
(3) Bolt and Nut
(4) Shock Absorber
(5) Rubber Bushing and Washer

Installation

1. Install rubber bushing and washer.
2. Install shock absorber.
3. Install rubber bushing and washer.
4. Install nut, then tighten it to the specified torque.
Torque: 20 N·m (14 lb ft)
5. Install bolt and nut, then tighten to the specified
torque.
Torque: 93 N·m (69 lb ft)
FRONT SUSPENSION 3C–5
450RW009