Installation - Isuzu 1999 RODEO Workshop Manual

2A–34 POWER–ASSISTED STEERING SYSTEM

Installation

1. Install steering wheel by aligning the setting marks
made when removing.
CAUTION: Never apply force to the steering wheel
in direction of the shaft by using a hammer or other
impact tools in an attempt to remove the steering
wheel. The steering shaft is designed as an energy
absorbing unit.
2. Tighten the steering wheel fixing nut to the specified
torque.
Torque: 34 N·m (25 lb ft)
3. Connect horn lead.
4. Support the module and carefully connect the SRS
connector.
NOTE: Pass the lead wire through the tabs on the plastic
cover (wire protector) of inflator to prevent lead wire from
being pinches.
5. Tighten bolts to specified torque.
Torque: 9 N·m (78 lb in)
6. Connect the yellow 2-way SRS connector located
under the steering column.
7. Connect the battery "–" terminal cable.
8. Turn the ignition switch to "ON" while watching
warning light. Light should flash 7 times and then go
off. If lamp does not operate correctly, refer to
Restraints section.