Installation - Isuzu 1999 RODEO Workshop Manual

30. Lift up the engine assembly.

Installation

CAUTION: When assembling the engine and
transmission, confirm that dowels have been
mounted in the specified positions at the engine
side. If assembled in the condition that dowels have
not been mounted in the specified position,
transmission damage can result.
1. position the engine assembly in the engine
compartment.
2. Tighten engine mounting bolt to frame side to the
specified torque.
Torque: 41 N·m (30 lb ft)
ENGINE MECHANICAL (X22SE 2.2L)
022RW005
022RW006
3. Install harness clip behind right horn.
4. Install the radiator grille and install flasher lamp
assembly.
5. Install two heater hoses to right side panel.
6. Install radiator lower hose to engine.
7. Install engine ground cable to chassis frame.
8. Connect two chassis harness connectors to right rear
side engine room(under fuse box) and install two
harness clips.
9. Install power steering pump assembly and tighten
fixing bolts.
10. Install transmission assembly, refer to installation
procedure for Transmission section in this manual.
11. Install propeller shaft, refer to installation procedure
for Propeller section in this manual.
12. Connect canister hose next to fuel piping connector.
13. Connect two fuel pipes at right side transmission by
quick type connector.
6A–37
022RW005
022RW006