Isuzu 1999 RODEO Workshop Manual page 263

4A2–30 DIFFERNTIAL (REAR)
9. While holding gears in place, insert LSD service
adapter J–39834 with long drive handle J–8592 in
differential shaft hole of case. Pull on long drive
handle J–8592 and rotate case, allowing gears to
turn. Make sure that holes in pinion mate gears align
with holes in case.
f It may be necessary to adjust tension on forcing
screw to rotate case.
10. Tighten forcing screw to compress the clutch packs,
to allow installation of spherical thrust washers.
11. Lubricate spherical thrust washers (2), and assemble
into case (1). Use a small screw driver to push
washers into place. Remove tools.
12. Position differential shaft in case and drive in with
hammer. Be sure lock pin hole of differential shaft (5)
is properly aligned to allow installation of lock pin (3).
Be sure that thrust washers and differential pinion
mate gears are aligned with the differential case (4).
Install new lock pin to proper depth using a punch.
Stake metal of case over pin in two places, 180
degrees apart.
901RW070
425RW012
425RW013