Reassembly - Isuzu 1999 RODEO Workshop Manual

6A–46 ENGINE MECHANICAL (X22SE 2.2L)
3. Remove oil seal (3).
4. Remove twenty fixing bolts (5) from inlet and exhaust
camshaft bracket, then camshaft brackets (4).
5. Remove camshaft assembly (6), (7).

Reassembly

1. Install camshaft drive gear assembly and tighten
three bolts to specified torque.
Torque: 50 N·m (37 lb ft) + 60° + 15°
2. Install camshaft assembly and camshaft brackets,
tighten twenty bolts on one side bank to the specified
torque.
1. Apply engine oil to camshaft journal and bearing
surface of camshaft bracket.
2. Align timing mark on intake camshaft and exhaust
camshaft to timing mark on camshaft drive gear
(one dot).
3. Tighten twenty bolts on numerical order one side
bank shown in the illustration.
Torque: 8 N·m (6 lb ft)
4. If it required to replace oil seal of camshaft drive
gear, use J–42609 for install the oil seal.
5. Tighten bolt for camshaft drive gear assembly
pulley to the specified torque.
011RW015
Torque: 50 N·m (37 lb ft) + 60° + 15°
014RW036